Latest front plate

General Questions and Comments that fit no specific category.
Post Reply
User avatar
GDK
God Shot
Posts: 166
Joined: Thu Jan 20, 2011 9:06 pm
Location: Ottawa, Canada

Latest front plate

Post by GDK »

The new front plate with the embossed "La Spaziale" right under the pressure gauge looks quite cool. Anyone considered buying and swapping plates?
Endo

Re: Latest front plate

Post by Endo »

At one time I considered swapping my single, round pressure gauge for the square dual gauge. This would require either carving up the existing front panel or buying a new one. When I asked, I think the price was $65 a few years back.
CaliforniaJed

Re: Latest front plate

Post by CaliforniaJed »

I have the new one and like it. While we're on the subject, is there a trick to aligning the pressure guage?
User avatar
GDK
God Shot
Posts: 166
Joined: Thu Jan 20, 2011 9:06 pm
Location: Ottawa, Canada

Re: Latest front plate

Post by GDK »

Loosen the nut holding the gauge just a little bit and push the gouge down so it goes down as much as possible. Then tighten but not too much so it can still move sideways - -this will help you align it as you mount the plate.
Post Reply

Return to “General Q&A”