Another Damaged flow meter alarm
Posted: Mon Nov 05, 2007 4:46 pm
Just wanted to say that in the last 2 weeks I've noticed reduced flow and a lack of crema. Today I just got a damaged flow meter alarm on both single shot and double shot buttons.
I looked on this forum and noticed that people were complaining of brass pieces in the volume meter. I called Chris coffee to make sure this would be the first thing to try and they agreed.
Make sure you turn off your water supply and releve alittle water pressure by pulling a 1 second shot then disconnect power.
The thing you are looking for right in front of the steam boiler. I took mine apart (you need a 4mm or 5/32's hex) and cleaned out everything. I noticed a small piece of brass. Also, there was some kind of deposits. This is strange as I have an inline softener and 0 on my hardness strips.
I made sure the propler is spinning freely and made sure to put everything back together correctly, including the screens and the springs.
After doing so, the flow is back to normal and I'm getting great shots again.
Hope this helps someone that is seeing this same problem.
I looked on this forum and noticed that people were complaining of brass pieces in the volume meter. I called Chris coffee to make sure this would be the first thing to try and they agreed.
Make sure you turn off your water supply and releve alittle water pressure by pulling a 1 second shot then disconnect power.
The thing you are looking for right in front of the steam boiler. I took mine apart (you need a 4mm or 5/32's hex) and cleaned out everything. I noticed a small piece of brass. Also, there was some kind of deposits. This is strange as I have an inline softener and 0 on my hardness strips.
I made sure the propler is spinning freely and made sure to put everything back together correctly, including the screens and the springs.
After doing so, the flow is back to normal and I'm getting great shots again.
Hope this helps someone that is seeing this same problem.